N1201SA UV RF Vector Impedance ANT SWR Antenna Analyzer Meter Tester 140MHz – 2.7GHz(English Version)+SMA-M connector for Handheld Radio



Specifications:

working currency 140MHz~2700MHz
stepped frequency 1kHz
Display 2.4cun TFT trdp
resolution ratio 320*240(QVGA)
2000mAH(7.4Wh)
power consumption <1.5W
charge current 400mA
charge port USB
Auto power off can be set 5-60minutes
measured parameters resistence reactance standing wave s11
resolution ratio 4 number
frequency accuracy about 5ppm
Connector SMA-K
measurement range:
impedance:0.1~1000
standing wave:1.000~65
s11(dB):0dB~-60dB

Remark: Press the second button and power button at the same to power on . Remark: Press the second button and power button at the same to power on .This instrument has four interfaces: single point measurement, scanning, system information, correction and calibration.
The default boot into single-point measurement interface. Note: For the convenience of the user, each time calibration correction options will automatically change to the user calibration. Meanwhile, in order to ensure the integrity of the calibration, the calibration process, the automatic shutdown function fails, the consistent boot.
Startup and shutdown Hold down the CTRL key off press the power switch button.
The boot state, long press (2S above) the switch button, after the release, the instrument will shut down The boot state, long press (2S above) the switch button, after the release, the instrument will shut down.
Remark: Press the second button and power button at the same to power on .

Leave a Reply

Your email address will not be published. Required fields are marked *